![]() ![]() ![]() The bond-primary directive, if needed, needs to be part of the slave description (eth0 in the example), instead of the master. # bond0 is configured using static network information. # bond0 is the bonding NIC and can be used like any other normal NIC. # eth1 ditto, thus creating a 2-link bond. # eth0 is manually configured, and slave to the "bond0" bonded NIC Add bonding-specific parameters to the bond NIC as follows.Įdit your interfaces configuration: sudo vi /etc/network/interfacesįor example, to combine eth0 and eth1 as slaves to the bonding interface bond0 using a simple active-backup setup, with eth0 being the primary interface:.Configure the bond NIC as if it were a normal NIC.Pick which available NICs will be part of the bond.Now you are ready to configure your NICs. Then load the bonding kernel module: sudo modprobe bonding In this case, the bonding module is automatically loaded when the bond interface is brought up.Įnsure that your network is brought down: sudo stop networking Note: Starting with Ubuntu 9.04, this step is optional if you are configuring bonding with ifup/ ifdown. # This file contains the names of kernel modules that should be loaded ![]() See Wikipedia for details.īefore Ubuntu can configure your network cards into a NIC bond, you need to ensure that the correct kernel module bonding is present, and loaded at boot time.Įdit your /etc/modules configuration: sudo vi /etc/modulesĮnsure that the bonding module is loaded: # /etc/modules: kernel modules to load at boot time. Descriptions of balancing algorithm modesīonding, also called port trunking or link aggregation means combining several network interfaces (NICs) to a single link, providing either high-availability, load-balancing, maximum throughput, or a combination of these. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |